Your system’s performance could suffer if you don’t take care of it, and it could even suddenly malfunction. You can perform many HVAC maintenance tasks independently, but some call for an HVAC contractor.
HVAC Tips for Utah's Climate
Replace the Air Filter
High-end filters can last up to a year, while basic one-inch filters may need to be changed every six to eight weeks. Even if you only perform this one DIY maintenance task, you could cut your heating and cooling costs by up to 15%.
According to HVAC experts, your filter’s type will determine when it needs to be replaced.
Clean the Coils on the Indoor Evaporator
You can clean the evaporator coils; otherwise, hire a professional for commercial HVAC service in Ogden, UT, to handle this HVAC maintenance task. Turn the unit’s power off by moving the HVAC circuit breaker to the off position.
Remove the evaporator coil cover and use a soft paintbrush to dust the coils. To finish the cleaning procedure, adhere to the product’s instructions. Make sure the drain pan flows freely by pouring hot water into it.
You Should Clean the Outdoor Condenser
If your air conditioner is a split system, one part is located outside on a concrete slab. Any dirt and debris that accumulates must be regularly removed for the heat exchange process to remain effective.
Clean the fins with a hose to eliminate dirt, cobwebs, grass clippings, and other debris. Trim the vegetation around the unit until the branches are no closer than 24 inches.
Maintain the Air Registers Open
You should balance your HVAC system’s airflow patterns. The system may become unbalanced if too many vents are closed or blocked. Keep at least 80% of your supply registers open to avoid this.
Then, ensure no rugs, furniture, or curtains are blocking any return vents. Experts of HVAC repair in Layton, UT, advise using the brush attachment on your vacuum to dust the grilles to improve airflow.
Adjust the Thermostat
It is advised to set the thermostat to 72 degrees in the springtime in Utah. Commercial HVAC, recommend setting your heater to turn on if the temperature drops below 68 degrees in the bottom range. When you are at home during the day, 78°F is the perfect temperature for the summer in Utah.
It’s a good idea to raise your thermostat’s setting to 85°F when you aren’t home, whether on vacation or gone all day. 68°F to 75°F is the recommended range for thermostat settings for fall in Utah. In the winter, Utahns should set their thermostats between 68°F and 72°F. Set your thermostat to 65 degrees Fahrenheit or lower at night to help save energy.
Hire the Best HVAC Contractor
There are still restrictions, even though there are many things you can do to ensure your HVAC system is operating at its best from season to season. To ensure the safety of your home, HVAC specialists are trained and required to adhere to building codes. If you need an HVAC contractor in Ogden, UT, ERS Heating & Cooling can help. Contact us at 801-732-6020 or drop us a mail here.